木门丈量过程中留意事项

　　木门丈量过程中留意事项

　　Wooden door advertent items in the process of measurement

　　1、请求木门洞完结墙面笔直无歪斜，摆布墙垛厚度共同，并在一个笔直端面上，否则也许呈现门整体装置不正或套线与墙体之间有缝且巨细不均的景象。品牌木门

　　1, request completion of wooden door hole wall straight without skew, at the mercy of the thickness of the wall battlements together, and on a straight face, otherwise may render the whole device is not straight or set of lines and wall body between seam and intrusive inequality. Brand wood door

　　2、丈量人员会依据现场实测洞口尺度，提出相应整改请求，请客户承认产品出产装置洞口尺度，并以此由客户落实施工队进行整改施工。

　　2, the hole dimension measurement personnel is on the basis of field testing and put forward the corresponding improvement request, please customers acknowledge the hole product output device scale, and improvement of construction in order to carry out the construction by the customer.

　　不一样系列门均有不一样的构造尺度，需在地上施工时留意不一样原料的分界方位(地板与地板，地板与砖石的压条方位)。避免呈现门扇落地处地上露出两种不一样材料的景象。

　　Different series door all have different structure dimensions, need to be on the ground of different raw material boundary position at the time of construction (floor and floor, the floor and masonry layering bearing). Avoid rendering door leaf fall is located in the ground to show two kinds of different materials.

　　3、如客户毛坯墙体厚度、宽度或高度在丈量时的数据与规范组合尺度不符时，需客户施工队在制品门出场装置前自行施工，可用板材、砖石料进行改制，如增加/剔凿墙垛，加高/下降门洞等。避免制品门无法顺畅装置。木门品牌

　　3, such as customer blank wall thickness, the width or height in the measurement data does not accord with standard combination scale, customer construction group before products door playing device will make their own construction, restructuring available plank brick, stone, such as increasing/pick carved wall battlements, heightening/drop door, etc. Avoid products door cannot smoothly device. Wooden door brand

　　4、如厅房与厨卫地上有高度差，应在丈量时与丈量师断定地上完结后的尺度，并在丈量单上标示，避免装置时呈现误差。在此强调阐明：装饰水平线为地上完结尺度及洞口实践高度的仅有参阅规范，因而，装饰水平线在丈量时必须清晰准确标示。

　　4, such as room, and hutch defends a height difference on the ground, measurement and measurement should be in the division of the scale of the judges at the end of the earth, and measurement in the list, to avoid device error. Emphasized to clarify here: the decoration for completion of the scale and the mouth of the practice of the height of the horizontal only refer to the specification, therefore, decorative horizontal line at the time of measurement must be clearly marked accurately.

　　5、制品门装置，套板与洞口装置端面需有10-25mm的装置胶缝。

　　5, products door device, set of face plate with hole device should be 10 to 25 mm device glue line.