套装门的装置过程?

　　套装门的装置过程?

　　The suit door installation process?

　　1、校正洞口

　　1, the correction of the mouth of the cave

　　洞口尺度是不是契合装置请求，不契合请求应予以必要的处理。实木门

　　The hole size is not fit device requests, don't agree with the request should be necessary to deal with. Real wood door

　　2、拆包

　　2, unpacking,

　　查看门框、门套线、挡门条、密封条，零部件是不是齐。

　　See, blocking the door, door frames, door cover line sealing strip, parts are together.

　　3、拼装门框

　　3, assembling the door frame

　　门框拼装时竖框与横框搭接处必须涂胶，然后用自攻丝予以固定。

　　Frame assembly mullion with transverse box it must glue, and then use the tapping to be fixed.

　　4、定位门框

　　4, positioning frame

　　门框按室内标高线就位，先用木楔从门框周围夹紧门框，再用工装和木楔从门框内口撑紧门框，经过夹门框表里木楔，调整门框竖直度、水平度及门框内径尺度，使其到达规划请求(门框与门扇空隙2.5-3mm/边，门扇与地上5-8mm)。木门30强

　　Frame according to indoor elevation lines are in place, with wooden wedge clamping frame from around the door frame, and labor and wooden wedge mouth hang from the door frame, through the wedge clamp frame list, adjust the frame of the vertical degree, levelness and doorcase inner scale, make its reach planning request (2.5 3 mm/side door frame and door leaf gap, door leaf and the ground 5-8 mm). Wooden door 30 strong

　　5、门框注胶

　　5, doorcase note glue

　　门框与墙体间填充发泡胶前首先要整理洁净墙体，用喷壶湿润墙面，填充发泡胶，留意发泡胶填充要适当，剩余发泡胶用刀片切平。

　　Frame between the wall and filled with bubble gum, first to clean the walls, with metope of wet watering can, filled with bubble gum, refer to the plastic foam filling to be appropriate, remaining blade cut out styrofoam.

　　6、装置门套线

　　6, door cover line

　　待4-6小时发泡胶固化后，卸下工装和木楔，在门框嵌槽内涂胶，然后将门套线嵌入门框，轻轻敲紧压实使门套线与墙体严密贴合。

　　Styrofoam for 4-6 hours after curing, tooling and wedge, embedded in the door frame groove glue, and then embed the door line frame, tight compaction makes the door line lightly with wall body tight joint.

　　7、装置门扇广州实木门

　　7, door leaf guangzhou real wood door

　　留意门的敞开方向，装置五金，门扇与门框空隙到达规划请求，确保门扇开关灵敏。

　　Keep an eye on the door open direction, device hardware, door leaf and door frame space to plan request, to ensure they switch is sensitive.