门扇的装置过程

　　门扇的装置过程

　　Door leaf device process

　　1)量出樘口净尺度，思考留缝宽度。断定门扇的高宽尺度，先画出中心缝处的中线，再画出边线，并保证梃宽共同，四边画线。实木复合

　　1) has grown two millimeters measure net scale, thinking seam width. Concluded that the height to width dimensions of the door leaf and draw the center seam line first, then draw a line, and ensure the Ting common wide, draw a line edges. Solid mu fu to join a

　　2)若门扇高、宽尺度过大，则刨除剩余有些，修刨时应先锯掉余头，再进行修刨。木门厂家介绍，门窗扇为双扇时，应先作打叠凹凸缝，并以敞开方向的右扇压左扇。

　　2) if the door leaf is high, the scale is too large, wide, excluding some remaining approximately plane should be cut off when fertilized, and then to repair the plane. Wooden door factory, door to door for the fan, arrange bump joint should be done first, and open to the direction of the right fan pressure left fan.

　　3)若门扇高、宽尺度过小，可在下边或装合页一边用胶和钉子绑刨光的木条。钉帽砸扁，钉入木条内1～2mm，然后锯掉余头刨平。

　　3) if the door leaf is high, the wide scale is too small, can be used on or below the hinge side tie plane light wood glue and nails. Flat head of nail down, nail into the wood within 1 ~ 2 mm, approximately and then sawed fertilized planing.

　　4)试装门扇时，应先用木楔塞在门扇的下边，然后再查看缝隙。合格后画出合页的方位线，剔槽装置合页。实木复合门

　　4) wardrobe door leaf, should use wooden wedge plug in the door leaf below, then check the gap. Draw the hinge line of bearing after qualified, carved slot device hinges. Solid wood composite door